Cleaning The Powerhead - Shark Rocket Powerhead AH450UK Manual

IMPORTANT: Remove Brushroll from unit before rinsing.
IMPORTANT: Make sure Brushrolls are completely dry before replacing in the vacuum.
Make sure unit is off and cord is unplugged.
STEP 1
STEP 4

CLEANING THE POWERHEAD

TO ACCESS THE BRUSHROLL
1 Slide the Brushroll Cover Release Buttons out�
2 Pull up to open the hood of the Motorised
Floor Nozzle�
3 Lift the tab on the Brushroll up to remove it
from the Motorised Floor Nozzle�
4 Remove any string, carpet fibers, or hair that
is wrapped around the Brushroll� The groove
on the Brushroll allows a pair of scissors to
cut the debris without damaging the bristles�
STEP 2
STEP 5
5 The Brushroll can be removed and rinsed
under running water� Let the Brushroll air-dry
completely before replacing in the Motorised
Floor Nozzle�
6 To reassemble, hold the Brushroll by the tab
and align the other end with the gear� Then
with the tab facing up, place the Brushroll in
the Motorised Floor Nozzle�
7 Close the Brushroll cover� Listen for a click and
make sure the release buttons are fully closed�
0 8 0 0 8 6 2 0 4 5 3
STEP 6
IMPORTANT: DO NOT place the Brushroll in the
dishwasher to wash or the dryer to dry� DO NOT
submerge the Brushroll in water�
IMPORTANT: Using a wet Brushroll in the
Motorised Floor Nozzle will void your warranty.
STEP 3
STEP 7
8