Problems And Solutions - EUROM LO50 Instruction Manual

Leave to dry thoroughly before repositioning in the device (follow the above
instructions in reverse order). Never use the dehumidifier without a filter!
The dehumidifier's housing can be cleaned with a damp cloth and a mild cleaning
agent. Never use corrosive or abrasive products as these could damage the finish.
Always remove the plug from the socket before carrying out any cleaning work!
TECHNICAL SPECIFICATIONS
Model
Connected power
Dehumidification l/day
Output capacity W
Power usage Amp.
Stackable
Dimensions cm
Weight kg
ERROR MESSAGES
The following error messages could appear on the display:
E1: Problem in the humidity sensor
E2: Problem with the sensor for defrosting pipes

PROBLEMS AND SOLUTIONS

The device does not work
 Device is switched off – switch it on
 Power failure – wait until power is restored
 Plug not (correctly) inserted into socket – resolve
 Melted fuse – replace the fuse
 LO50: water reservoir full – drain it
The device is not dehumidifying very effectively
 Filter blocked by dirt – clean filter
 Obstacle in air inlet or outlet – remove blockage
 Door or window open – close the door or window and shade the sun
 Coolant leakage – contact a service department
Water leak
 Device tips over – place on a stable and horizontal surface
 Drain is blocked – remove blockage
Peculiar sounds
 Device is not stable – place it on a stable and horizontal surface
 Filter is blocked – clean filter
1. When you switch the device on or off, the circulation of the coolant can make a
certain amount of noise; this is perfectly normal.
2. The air that is emitted from the air outlet may well be warm; this is perfectly
normal.
3. If you cannot resolve the issue with the above instructions, please contact your
supplier or a recognised repair company. Never open the device yourself!
19
LO50 LO70
220-240 V / 50 Hz
50 70
900 1360
4.2 6.35
+ (max. 2) -
41x43x59 54x37x92 66x43x109
35 44
LO120
120
1650
7.7
-
57