Table of Contents
Advertisement
EN
III.6 ELECTRICAL CONNECTION
The electrical connection must be carried out ONLY by qualified technicians.
The electrical protection of the electrical connection upstream of the equipment must
comply with the regulations in force.
Caution!
indicated on the serial number plate located on the appliances
correspond to those available at the installation site.
Any change to the electrical installation necessary to install the hood should only be
undertaken by qualified staff.
After installation, insulated parts and those carrying electricity must be protected from
any possible contact.
Caution! If the electrical connection is carried out incorrectly or not
meeting the regulations, it may damage part of the appliance and the
warranty will not be valid.
Caution!
power mains (fig.1-2 WARNING chapter).
These appliances must be earthed.
Two types of connections to the network are possible:
Using a standard plug connected (Fig. 4.1) to the power cord and inserted
1.
into an accessible socket outlet (to be disconnected during service operations).
Make sure that the plug is accessible even after the complete installation of the
appliance.
Fig. 4.1
Make sure that the voltage (V) and frequency (Hz)
Before any intervention, disconnect the appliance from the
47
Advertisement
Table of Contents
