Table of Contents
Advertisement
EN
Before fixing the induction hob, glue the foam gasket included on the inferior part of the
glass.
Caution! It is forbidden to install the hob without the foam gasket!
Remove the protective film and glue the gasket at 2mm distance from the glass edge
(A=2mm), the gasket must be attached along the entire length and should not overlap at
the corners (Fig.3.10).
Fig. 3.10
Lay in the silicone sealant flush at the hole (Fig. 3.11), place the induction hob (Fig.3.12)
Fig. 3.11
Fig. 3.12
42
Advertisement
Table of Contents
