Table of Contents
Advertisement
4. Unpacking and assembly
An unpacking instruction is available inside the crate. Follow the instructions carefully to prevent damage during unpacking.
4.1 Parts inside the crate
The crate contains the following items:
•
Hopper (input tube).
•
Discharge tube (output or conveyor).
•
Handle.
•
Machine (chassis, motor and rotorhouse).
•
Manual and unpacking instructions.
•
Bag with tools (wrench for starter plug & screw driver) and bolts and nuts (4 long allen bolts (M8x25), 2 short allen bolts (M8x16), 4
rings, 2 wingnuts, and 2 bolts with handle).
•
Key for de-blocking the rotor.
4.2 Assembly instructions
The following tools are needed during assembly: Allenwrench 6
4.2.1. Assembly of the hopper (input tube)
The hopper (input tube) is big and heavy. We suggest to never lift it alone.
When mounting the hopper on the machine, the machine
can get out of balance. Support the bumper on the chas-
sis to prevent the machine from tilting
Always mount the hopper (input tube) first. It is not
possible to mount the hopper when the discharge tube
(output) is installed on the
Put the hopper on the floor in front of the machine. Make sure
the hinges are on the bottom, facing the machine.
Lift the hopper and hold it above the rotor housing. Slide the
hinges in the holes on the rotor housing.
Tilt the hopper to the front until it touches the rotor housing.
(Fig. 7). Use the 2 long allen bolts (M8x25), 2 spring washers
and two rings to fix the hopper to the rotor housing.
Tighten firmly. (Fig. 8)
Advice: Put the spring washers over the bolt before putting the
rings.
4.2.2. Assembly of the output tube
Put the output tube on top of the output hole of the rotor
housing (Fig 9). Take the 2 long allen bolts (M8x25) and 2 short
allen bolts (M8x16), and 4 spring washers to fix the output tube
to the rotorhousing (Fig. 10). The long allen bolts are used on
the back of the machine, the short allen bolts are used on the
front side of the output tube (facing the input tube). Tighten
firmly.
It doesn't matter how you orientate the output tube. This is a user decision. Both directions are possible. This allows the user to choose
the output direction (Fig 11a and Fig 11b).
4.2.3. Assembly of the handle
Assemble the handle on the chassis. Put the long bolts with handle through the chassis and through the handle. Tighten firmly.
4.2.4.
Assembly of the (optional) turnable output
Please refer to the manual of the turnable output for the proper instructions.
Manual GTS-1000MZ - EN - D09-GV09020-01
(Fig. 5)
machine.
(Fig. 6)
Fig. 5
Fig. 7
Fig. 9
Fig. 10
6
Fig. 6
Fig. 8
Fig. 11.a
Fig. 11.b
www.vilagrancha.com
Advertisement
Table of Contents
