Table of Contents
Advertisement
1.3 Safety directions for use and maintenance
Do not leave the key (when applicable) in the ignition. Never leave the keys unattended. Keep out of reach of children and unautho-
rised persons. Disconnect the spark plug wire before attempting to do maintenance on the machine.
Wait until the engine is cooled down before attempting maintenance on the machine.
During servicing disconnect the battery, if applicable.
The blades have to be sharp and well balanced.
Never repair bent or damaged blades, but replace them. Always use ORIGINAL blades for your own safety!
Do not use, nor perform maintenance in the absence of light.
Remember that operating the starting mechanism on engine powers machines will still cause the cutting means to move.
1.4 Explanation of the stickers and safety symbols (Fig. 4)
Sticker 1:
Watch out:
danger!
Read the
users' manual
carefully
Danger of
flying debris
Keep a
sufficient
GTS 900
GTS 900
distance (12 m)
2013
2013
132 kg
132 kg
Risk of severe
cuts and
GTS 900
GTS 900
wounds
2013
2013
132 kg
132 kg
Risk of
getting stuck
2. Description and technical service
2.1 Type description
Each GTS1000MZ woodchipper is provided with a factory identification and serial number plate with the most important dates. You can
find this plate on the chassis between motor and rotorhousing.
2.2 Service
This manual contains the instructions for the operation and basic maintenance of the GTS woodchipper. An authorized service dealer
should carry out all other adjustments. It is advised to have the machine serviced once every year by an authorized service dealer.
2.3 Spare parts
Always use ORIGINAL spare parts, which are safe and guaranteed replacements.
2.4 Warranty
The warranty will be granted in accordance with the text on the last page of this instruction manual.
3. General description
The GTS1000MZ is a woodchipper intended to shred all kinds of fresh cut wood with a diameter of maximum 8 cm. It is also possible to
shred roots, but the roots need to be cleaned from sand, earth, rocks or any other materials.
The machine consist out of an engine that propels a rotor using two belts. On the rotor there are two blades installed. Via an infeed
tube the cut wood is introduced into the rotor where the material is shredded. The shredded material is then discharged via the output
tube. An optional turnable output can be installed and allows to change the direction of the output.
On the rotorhousing one counter blade is installed.
www.vilagrancha.com
Sticker 2:
Danger of
flying debris
Keep a
sufficient
distance (12 m)
GTS 900
2013
132 kg
Sticker 5:
2013
132 kg
Sticker 3:
Risk of severe
cuts and
wounds
Risk of
getting stuck
Serial number
plate
5
Sticker 4:
Sticker 6:
D.05.WARNHOT-02_Warning_hot-surface - 38x38mm_BW.pdf 1 8-6-2016 11:35:16
C
M
Y
CM
Hot surface –
MY
CY
Risk of burns
CMY
K
Sticker 7:
Lwa_115dB_40x36mm.pdf 1 20-8-2014 8:45:43
Noise level
Manual GTS-1000MZ - EN - D09-GV09020-01
Read the
users' manual
carefully
Wear safety
goggles, ear
protection and
safety gloves
Fig. 4
Advertisement
Table of Contents
