Advertisement
If the battery voltage is low, the battery symbol will be
displayed on the screen and soon afterwards, the
wrench will turn off. Replace with a new set of
batteries.
INITIAL OPERATION:
3.2
Power On.
3.2.1 Place the wrench on a horizontal level surface
and press the
wrench.
3.2.2 Press the
wrench off.
SET-UP
3.3
Track Mode: After turning on the torque
wrench it will be set in 'track' mode.
This means once the torque is reached and
pressure is taken off the torque wrench the
display rolls back down to ZERO.
3.4
Peak Hold Mode: use the wrench in exactly
the same way, except that when the force is
released, the display stays at the maximum
torque that has been applied.
After two seconds the display will flash. Either
continue on the next operation or press the
button to ZERO the value and continue onto
the next operation.
3.5
Track and Peak Mode Setting.
3.5.1 Press the
3.5.2 Press the
button to enter mode selection.
3.5.3 Press the
T
Track
3.5.4 To confirm, press the
Note: If no buttons are pressed within 3 seconds
the display will return to the main screen.
3.5.5 After confirming, the screen will automatically
move onto the next setting (unit selection).
button to turn on the torque
button again to turn the
button to turn the wrench on.
button to select:
P
or
Peak
button.
3.6
Unit Selection.
3.6.1 When the peak or track mode has been
confirmed the wrench will go to unit selection.
3.6.2 Nm will be shown, Press the
scroll through different measurements.
3.6.3 Press the
Note: If no buttons are pressed within 3 seconds
the display will return to the main screen.
3.6.4 After confirming, the screen will automatically
move onto the next setting (Auto Power Off).
3.7
Auto Power Off
3.7.1 When the unit selection has been confirmed
the wrench will go to Auto Power Off setting.
3.7.2 On the auto power off screen the default time
will be shown (5 minutes).
3.7.3 Press the
settings.
5 Minute
3.7.4 To confirm, press the
Note: If no buttons are pressed within 3 seconds
the display will return to the main screen.
3.7.5 After confirmation, the screen will return to the
main screen.
PROGRAMMING THE TORQUE AND ANGLE.
The wrench has the ability to hold 5 torque and angle
settings in its memory
3.8
Torque Setting
3.8.1 Press the
3.8.2 Press the
memory storage numbers M1 - M5
3.8.3 After choosing which memory slot to use hold
down the
3.8.4 Release the button when 'SET' is shown on
the screen.
3.8.5 The last saved torque will be shown.
3.8.6 Press the
3.8.7 Press the
turn, press the
digits.
3.8.8 To confirm the torque figure is set, press the
Note: If no buttons are pressed within 6 seconds
the display will continue to the angle setting.
Note: 'Erro' will be shown on the screen if the
torque set does not fall between 10% and
100% of the range of the wrench.
Original Language Version
Nm
lbf.ft
lbf.in
kgf.m
button to confirm.
button to scroll through the
15 Minutes
button.
button to turn the wrench on.
button to scroll through the
button for 2 - 5 seconds.
button to ZERO the figures.
button to change each digit in
button to move between
button. Setting the angle will proceed.
button to
No Auto
Power Off
STW306
Issue: 1 - 04/10/11
Advertisement
