Unpacking; Connecting; Startup - BELINEA 10 20 05 User Manual

UNPACKING

Carefully lift the monitor out of the packaging and make
sure that all components are included (see fi g. 1).
Save the original box and packing material in case you
have to ship or transport the monitor.
To set up the device, you must fi t the monitor base
together.

CONNECTING

± To connect the monitor to your PC .........................
1. Make sure that the PC and monitor are unplugged.
2. Connect the 15-pin signal cable to the monitor and
the PC (see fi g. 2a).
3. If you have a graphic card with a digital DVI-D con-
nector (24-pin socket), then connect one end of
the DVI-D cable (optional) to the DVI-D connector
of your monitor (see fi g. 2b), the other end to the
computer.
Figure 2a. Connecting the monitor to the PC
± Connecting the audio cable ....................................
If your computer is equipped with an audio output port,
then connect one end of the sound cable to the audio
input connector of the monitor (
end to the Line-Out connector of the computer.

STARTUP

1. First start your PC and then turn on your Belinea
monitor using the power switch (
status indicator ( in fi g. 4) should light up green.
Signal cable
in fi g. 3) and the other
in fi g. 4). The
MENU
MENU MENU SELECT/AUTO SELECT/AUTO
MENU
SELECT/AUTO
Figure 1. LCD Monitor
Figure 2b. Connection via the DVI-D interface
3
2
Figure 3. Connecting the monitor to the power source
± To connect the monitor to the power source ........
1. Connect the separate power cable (
the monitor and a grounded outlet.
2. The monitor is equipped with a main power switch
located on the back, next to the power cable socket
( in fi g. 3).
2. Adjust the image to meet your requirements (see the
following sections "Basic Setup" and "Image settings
using the OSD menu").
3. If there is no image displayed on the monitor, consult
the section "Troubleshooting".
ENGLISH
Power cord
Audio cable
VGA cable
DVI-D cable
(optional)
DVI-D cable
1
in fi g. 3) to
Operating Instructions - 11