Table of Contents
Advertisement
1.
Prepare the Wall
3/4" Plywood
Contreplaqué de 3/4"
Madera contrachapada de 3/4"
NOTICE: Select 3/4" plywood with a maximum height of 9" (22.9 cm). This will
provide proper structural integrity for the vanity installation.
Measure and mark 33" (83.8 cm) up from the floor. This will be the height from
the top of the 3/4" plywood to the floor.
Notch the studs so the front of the 3/4" plywood will be flush with the edge of
the studs.
NOTICE: The backing should be at least 30" (76.2 cm) long and be aligned with the
vanity.
Secure the 3/4" plywood to the studs with framing nails.
Install the water supply and drain lines according to the roughing-in information
provided with your lavatory. The water supply nipples must extend at least 3" (7.6
cm) beyond the finished wall material.
NOTE: Plumbing fittings will be exposed and visible once the vanity installation is
complete. Plated plumbing fittings are recommended.
Complete the finished wall. Ensure the finished wall is straight and plumb, and
the floor is flat and perpendicular to the finished wall.
NOTICE: Before installing molding to the finished wall, check to ensure that it will
not interfere with the vanity.
Préparer le mur
NOTICE: Sélectionner du contre-plaqué de 3/4" avec une hauteur maximum de 9"
(22,9 cm). Ceci fournira une bonne intégrité de structure pour l'installation du
meuble.
Mesurer et marquer 33" (83,8 cm) vers le haut à partir du sol. Ceci sera la hauteur
à partir du dessus du contreplaqué de 3/4" au sol.
Encocher les montants de manière à ce que le contreplaqué de 3/4" soit à égalité
avec le rebord des montants.
Kohler Co.
9" (22.9 cm)
33"
(83.8 cm)
30" (76.2 cm) Min/Min/Mín
5
1105377-2-B
Advertisement
Table of Contents
