Advertisement
Connecting a MONO / SUBWOOFER Speaker
1.
Plug the external speaker's audio cable to the 6.3mm or 2P PHOENIX jack on the rear panel.
The speaker's impedance must be 4Ω or more. When using 2P PHOENIX for connection, please accord with
the positive (+) and negative (-) polarities.
IMPORTANT – Either 6.3mm or 2P PHOENIX jack can be connected.
2.
Slide the switch to MONO (BYPASS) mode when connecting to a mono speaker. SUB mode to a subwoofer.
3.
There is crossover control on the rear panel for external subwoofer speaker. This control can decide the frequency
to amplify or mute the audio. Only audio below the crossover frequency will be amplified to the subwoofer speaker.
4.
Turn on the power and then adjust SUB/MONO volume control on the front panel to a desired level.
5.
Bass and treble tone levels can be adjusted on the front panel.
OPERATION MANUAL V1.0
MA4200
PAGE 7
Advertisement
