Pch Storage Configuration - Asus DN-300-R2 Manual

DVMT Pre-Allocated [64M]
Allows you to select DVMT 5.0 Pre_Allocated (Fixed) Graphics Memory size
used by the Internal Graphics Device. Configuration options: [32M] [64M]
[96M] ~ [1024M]
RC6(Render Standby) [Auto]
Allows you to enable or disable render standby support. Configuration
options: [Disabled] [Auto]
PEG Port Configuration
Allows you to configure the PEG Port settings.
PCIEX16_1 Link Speed [Auto]
Allows you to configure the PCIEX16_1 speed. Configuration options: [Auto]
[Gen1] [Gen2] [Gen3]
3.3.4

PCH Storage Configuration

While entering Setup, the BIOS automatically detects the presence of SATA
devices. The SATA Port items show Empty if no SATA device is installed to the
corresponding SATA port.
SATA Controller(s) [Enabled]
Enables or disables onboard the SATA device. Configuration options: [Disabled]
[Enabled]
The following items appear only when you set SATA Controller(s) to [Enabled].
SATA Mode Selection
This item allows you to set the SATA configuration.
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to use the
AHCI (Advanced Host Controller Interface). The AHCI allows the
onboard storage driver to enable advanced Serial ATA features
that increases storage performance on random workloads by
allowing the drive to internally optimize the order of commands.
Aggressive LPM Support [Disabled]
This item is designed for LPM (link power management) support with a better
energy saving conditions. When disabled, the hot plug function of SATA ports are
disabled. Configuration options: [Disabled] [Enabled]
SMART Self Test [Disabled]
This item allows you to enable or disable the SMART Self Test on all HDDs during
POST. Configuration options: [Disabled] [Enabled]
SATA6G_0(White), SATA6G_2(Blue), SATA6G_3(Black) [Enabled]
Allows you to enable/disable the SATA6G ports. Configuration options: [Disabled]
[Enabled]
Chapter 3: BIOS setup
3-9