Advertisement
REWINDER GUIDES ALIGNMENT
ULTRASONIC SENSOR CALIBRATION
1. Take a paper clip and insert it into the little hole located next to the OFF-ON
switch and push it down for 5 seconds. The yellow led will light up.
2. Raise the tension arm. The yellow led will stay on.
3. Once again, insert the paper clip down into the hole for 5 seconds. The led will
light off.
Ultrasonic sensor calibration complete.
WARNING:
Before proceeding with the ultrasonic sensor
calibration, turn "OFF" the module that needs to be calibrated
(laminating or matrix removing).
Metal glides adjustable to obtain rolls of
labels perfectly aligned.
Advertisement
