Table of Contents
Advertisement
Note: If a device has not been
'paired' or connected with
your Bluetooth speaker after 5
minutes, the blue LED indicator
will begin to flash slowly. Press
and hold the 'Volume/Standby'
knob to go to Standby mode
and then press and hold again
to switch back on. The LED
indicator will begin to flash blue
quickly again.
2. On the device that you would
like to connect to your Bluetooth
speaker via Bluetooth (e.g.
iPhone/iPad/Android/other
phone/Computer), turn on
Bluetooth connectivity and
ensure that it is 'discoverable' .
Note: If necessary, refer to the
instructions for your device to
add or set up Bluetooth
3. Select to 'Add new device' , if
necessary.
Note: Some products will
automatically search for a new
device and so the 'Add new
device' option is not available.
4. When found, your Bluetooth
speaker will be displayed as
'BUSH Audio' . Select the device
name to begin pairing.
5. When pairing is complete the
LED indicator around the volume
control will stop flashing and will
remain on.
6. Now that you have paired
your device with the Bluetooth
speaker, it will connect to it when
it is within range, which is about
10 metres or less (33 feet or less),
line of sight.
NFC touch point
Your Bluetooth speaker has an
NFC touch point to enable quick
and easy Bluetooth pairing with
other NFC enabled devices.
In Bluetooth mode, just touch
your other NFC enabled device to
the NFC logo on the top of your
Bluetooth speaker to pair.
Change the mode
Briefly press and release the
'Volume/Standby' knob to
change modes. Bluetooth/iPod
and Aux in modes are available.
.
Blue
Green = iPod mode
Red
6
= Bluetooth mode
= Aux in mode
Advertisement
Table of Contents
