Table of Contents
Advertisement
S
REMOVING / REPLACING THE CAMERA
Proc Sheet 1 11
myX-6/myV-65
2/2
Tools :
- A 0.6mm torx screwdriver
- Gloves
- Insertion/extraction Flex tool
- Tweezers
Notice: This procedure must be performed by an technician provided with gloves , to avoid any risk
of pollution.
Preliminary operation :
1. Remove the back cover (
Proc sheet 0
01).
2. Remove the battery (
Proc sheet 0
02).
3. Remove the front cover (
Proc sheet 0
03).
4. Unscrew the six attachment screws on the electronic board.
5. Remove the assembly display , then the light guide keypad
(Proc sheet 1 02 / 1 03)
6. Remove the electronic board
(2).(Proc sheet 1
04)
Removal procedure :
1. Use tweezers to remove camera joint
2. Remove the radio shielding (1) by means of tweezers
3. Lift connector lock up (4)
4. Remove delicately the camera (5)
Placement procedure:
1. Check that the connector lock (4) is lift up
2. Present the assembly camera (1) front of Zif connector (4)
3. Insert delicately the flex PCB into the Zif connector by using the flex tool
4. Press down the connector lock
5. Replace a new radio shielding (1)
6. Stick a new camera joint (3) on the radio shielding (1)
Further operations :
1. Remove the electronic board on the assembly plate (2).
.(Proc sheet 1
04)
2. Replace the light guide keypad
(Proc sheet
1.03)
3. Replace the assembly display
(Proc sheet 1 02)
4. Position and tighten the six attachments screws with torx settings of 0,25 N.m.
5. Replace the front cover /battery / back cover
(Proc sheet 0 01 / 0 02 / 0
03).
6. Carry out the radio test
(Test Sheet
06).
Ref. SCT U38 SSC DTS 0012 – Index A - May 12 , 2003
Page 5-35
Advertisement
Table of Contents
