Advertisement
Temperature alarm settings
The temperature alarm settings are shown in the middle-lower part of the program window. By
clicking on the checkbox to the left of the temperature inputs T1 and T2, you can select which
temperature inputs of the module will be used and enable their settings. These settings can be
different for each input and have the following options:
Temperature alarm type – The temperature alarm can be triggered at a higher or lower
temperature than the set limit. In this case, if the ring alarm is selected, the module will
ring the selected users in the selected interval for the duration of the temperature alarm
until the call is rejected (hang up) by the user. The other two types of temperature alarm
allow to ring the selected users once when the temperature exceeds or falls below the
set limit
Temperature limit – Set the temperature at which the temperature alarm should occur.
Temperature alarm notification – Select the way how the selected users should be
informed about the temperature alarm. It can be a free ringing or an alarm SMS.
Count of users to be notified – Set the number of users to whom the temperature
alarm should be sent. Alarm is then sent in the order in which their numbers are stored in
the module.
Both temperature inputs share the following settings of interval and duration of user notification:
Notification interval (min) – Set the interval of ringing the selected users in minutes.
The user can end the ringing by rejecting (hanging up) the call.
Notification duration (sec) – Set the duration of each ringing in seconds
Reset to factory defaults
This button is intended to reset the G2S-T module to its default (factory) settings.
Other settings
In the right part of the program window, you can set the operation of the G2S-T module in the
event of a power failure. In the event of a power failure, the module is powered from its built-in
accumulator and after the set Blackout notification delay, the module notifies the selected
number of users of the power failure. If the power failure continues, the module remains in
operation and is powered by its built-in accumulator until the Switch off notification delay is
reached. If the Switch off notification delay expires, the module notifies the selected number
of users of the shut-down and then shuts down.
After editing, it is necessary to press the Write button to write the modified settings to
the G2S-T module, otherwise the changes will not take effect and the modified data will
be lost! Because logging the G2S-T module into the GSM network is blocked during its
connection to the USB port of the computer, after writing the required data it is
necessary to disconnect the module from the computerʼs USB port first, and then
connect it to the power supply. The connection to the USB port is intended only for the
module setting; after that, the module must always be disconnected from the USB port!
- 6 -
Advertisement
