Advertisement
Output settings
The G2S-T module output relay settings are shown in the middle-upper part of the program
window. These settings are as follows:
Pulse output (monostable) – With this option, one pulse of the set duration appears on
the module output after ringing from the authorized phone number. According to the set
logic of its switching, the relay switches on or off for the set period of time.
o Pulse duration – Set the output relay on/off period of time in the monostable mode.
You can set 0.1 to 6553 seconds (i.e. approx. 109 minutes).
o Relay logic – Set the default relay state before ringing. The option direct (N.O. -
normally open) means that the relay is open before ringing and switches on for the
set period of time after ringing from the authorized number. The option inverse (N.C.
- normally closed) means that the relay is closed before ringing and switches off for
the set period of time after ringing. A detailed description of N.O. and N.C. is based
on the usual designation of the relay contacts
Switch output (bistable) – This option always changes the state of the output relay to
the opposite state after ringing from the authorized phone number and this state lasts
until the next ringing.
o Relay state after reset – Allows to set the default relay state in the bistable mode
after power-up. It is possible to select ON – relay closed, OFF – relay opened, and
as before RST i.e. the same state as before power failure or switching off the power
supply of the module.
Safe open (ring and hang up to open) – This option provides protection against
unintentional activation of the controlled device by accidentally pressing the mobile
phone keys in the purse bag, jacket pocket etc. If this option is active, you must ring the
G2S-T module and hang up after the first ring tone. The module then performs the
required action. Otherwise, i.e. without hanging up after the first ring, the call will be
rejected, and the output relay will not be activated. No call is charged.
Anti-vandal mode (answer and hang up all unauthorized phone numbers) – This
option is designed to limit attempts to connect to the module phone number from
unknown phone numbers (e.g. telemarketing agencies). In the anti-vandal mode, the
G2S-T module receives a call from an unknown phone number and then hangs up
without performing any action. Such a call is charged. When calling from the authorized
phone number, the module hangs up and activates the output relay without charging the
call.
- 5 -
Advertisement
