Advertisement
When the adapter brackets are installed, the
completed assembly displays as follows.
QuickPanel+ 7" Display adapter Assembly Fully
9.
Using a slotted screwdriver, tighten the clamp
screws against the rear panel surface to a
maximum torque of 0.23 to 0.45 Nm (2 to 4 in-lb).
Note: Screws should be tightened applying a
uniform pressure to the adapter gasket
against the front panel surface. Mounting
clamps hold the unit in place by tension;
no drilling is required.
10.
Reconnect any cables that were removed in step
1 of this procedure. If an SD card was removed,
install it in the SD port.
14
IC755ACC07ADP Installation Guide
Seated in Panel
GFK-2895A
Advertisement
