Steps
1. Align the smart card reader, and replace the eight (M2x5) screws that secure smart card reader to the system chassis.
2. Align and replace the wireless passthrough daughterboard on the system chassis.
3. Replace the copper adhesive shield to secure the wireless passthrough daughterboard to the smart card reader holder.
4. Replace the two (M2x5) screws that secure the wireless passthrough daughterboard to the system chassis.
5. Connect the smart card reader cable to the connector.
6. Flip the smart card reader cable.
Next steps
1. Install the
docking
board.
2. Install the
system
board.
3. Install the
coin-cell
battery.
4. Install the
front
camera.
5. Install the microphone.
6. Install the WWAN.
7. Install the WLAN.
8. Install the
solid-state
drive.
9. Install the
system
fan.
10. Install the heat-sink.
11. Install the
display
assembly.
12. Install the batteries.
13. Follow the procedure in
after working inside your
tablet.
Removing and installing components
63