Next steps
1. Install the
display
assembly.
2. Install the batteries.
3. Follow the procedure in
Microphone
Removing the microphone
Prerequisites
1. Follow the procedure in
2. Remove the batteries.
3. Remove the
display
assembly.
About this task
The figure indicates the location of the microphone and provides a visual representation of the removal procedure.
Steps
1. Open the latch and disconnect the microphone cable from the connector on the system board and remove the screw (M2x5) that
secures the integrated microphone assembly circuit board to the system board.
2. Release the microphone assembly and, lift the microphone from the tablet chassis.
NOTE:
NEVER pull the microphone by the cable. In case the circuit board is not released smoothly, push from below
the microphone circuit board by a plastic scribe.
Installing the microphone
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
after working inside your
tablet.
before working inside your
tablet.
Removing and installing components
37