Adjusting The Traction-Drum Position; Adjusting The Handle Height; Transporting The Machine To A Job Site - Toro Greensmaster 1021 Operator's Manual

Figure 13
1. Reel-speed-control knob (shown in the high-reel-speed
position)
Adjusting the
Traction-Drum Position
The traction drum can be adjusted to 2 positions:
•
L position: Use this position for mowing at a
OW
lower height of cut (e.g., mowing a golf-course
green).
•
H position: Use this position for mowing at a
IGH
higher height of cut (e.g., mowing a golf-course
tee box).
1. Move the kickstand to the C
position; refer to
2. Remove the shoulder bolts
side of the machine that secure the drum drive
housing to the chassis.
-U
UTTING NIT
Kickstand (page 10).
(Figure 14) on each
1. Insert shoulder bolt here
for the L
2. Insert shoulder bolt here
g275053
for the H
3. Align the holes in the chassis with the holes in
the drive housing.
4. Use the previously removed shoulder bolts to
secure the drive housing to the chassis
14).
5. Move the kickstand to the S
refer to
Adjusting the Handle
Height
Use the handle-height adjuster to adjust the handle
height to a comfortable operating position; refer to
Handle-Height Adjuster (page
S
ERVICE
Transporting the Machine
to a Job Site
Transporting the Machine Using
Transport Wheels
Use the transport wheels to transport the machine a
shorter distance.
1. Install the transport wheels; refer to
the Transport Wheels (page
14
Figure 14
Left side of the machine shown
3. Shoulder bolt
position.
OW
position.
IGH
Kickstand (page 10).
10).
g277026
(Figure
position;
TORAGE
Installing
19).