Advertisement
7
STEP 7. Screw in the four adjustable leg
levellers (R). Bolt the four corner braces (I) into
position using 16 bolts (O), 16 lock washers
(P), and 16 nuts (Q)
10
STEP 10. Attach a left hand female slide (K) to
left hand side of each draw and a right hand
female slide (K) to the right hand side of each
draw (see diagram 11). Engage each draw onto
the protruding male slides and push fully home,
then open the draw to check that it is retained.
8
STEP 8. Place the wooden top (N) face down
on a flat, clean, smooth surface. Position the
cabinet upside down on the wooden top and
mark the hole locations on the top. Move the
cabinet to one side and drill 5/32” diameter x
1/2” deep holes in the top. DO NOT DRILL
DEEPER THAN 1/2”. Attach frame to top with
the 4 hex head screws (S).
11
Diagram 11. Orientate each slide as shown in the diagram above with the rear hook pointing
towards the rear of the draw or the rear of the cabinet. Put the rear hook on each slide into the
square hole nearest the back of the draw or the back of the cabinet and push the slide backwards
to engage the hook. Swivel the front of the slide up or down slightly until the other two hooks appear
in the other two holes. Keep the rear face of the slide up against the draw or slide panel. On the
draws pull the slide sharply upwards to engage it. On the cabinet push the slides down to engage.
9
STEP 9. Take the 4 male slide components (M)
and slide 2 onto the female slides on the left of
the draw compartment and 2 onto the female
slides on the right hand side of the draw
compartment. Push them fully in to engage
them, then pull them out to the stop point.
AP2020 - 1 - 061005
Advertisement
