Advertisement
3.
ASSEMBLY
1
STEP 1. Take two crossrails (B) and bolt them
to the cabinet sides (A) using 8 bolts (O), 8 lock
washers (P), and 8 nuts (Q). Ensure that the
pairs of holes that accept the corner braces are
facing downwards. (Refer to STEP 7.)
4
STEP 4. Take two crossrails (B) and bolt them
to the cabinet sides (A) and centre supports (C)
using 12 bolts (O), 12 lock washers (P), and 12
nuts (Q).
2
STEP 2. Bolt the two centre supports (C) to the
front and back crossrails respectively using 4
bolts (O), 4 lock washers (P), and 4 nuts (Q).
5
STEP 5. Take two draw stops (G) and one back
panel (F) and bolt them to the back of the
cabinet with the draw stops between the panel
and the cabinet. Repeat procedure with the
other back panel and 2 draw stops. Use 8 bolts
(O), 8 lock washers (P), and 8 nuts (Q).
3
STEP 3. Bolt 2 left & 2 right slide panels (D) &
(E) into position, only bolt at front of Work
Bench using 8 bolts (O), 8 lock washers (P),
and 8 nuts (Q). Fix 1 left hand female slide (L),
at top onto each slide panel (D) and 1 right
6
hand female slide (L), onto each slide panel (E)
Refer to Diagram 11 on how to fit slides.
STEP 6. Turn the cabinet upside down and bolt
the two shelf components (H) into position at
the bottom of the unit using 8 bolts (O), 8 lock
washers(P), and 8 nuts (Q).
AP2020 - 1 - 061005
Advertisement
