Eastwood MP200i Instructions Manual page 9

INSTALLING THE GROUND CABLE AND CLAMP
• Locate the Ground Clamp with Cable and connect the plug on the cable end
to the Ground Cable Connector (–) on the Welder. Align the key of the brass
ferrule with the notch of the receptacle at the 12:00 position (FIG 6), insert
the plug and twist Clockwise 1/2 turn until it is tight (FIG 7).
CHANGING THE POLARITY FOR WELDING WITH FLUX CORE WIRE
The Eastwood MP200i comes set up to weld with Solid Wire and Shielding Gas (FIG
8). To use a Flux Cored wire, the Polarity of the short Cable Lead attached to the
Front Panel must be reversed (FIG 9).
ELECTRIC SHOCK CAN CAUSE INJURY OR DEATH!
Disconnect Welder from power supply before beginning.
• Disconnect the short Cable Lead from the Positive (+) Connection Receptacle
by rotating the Rubber Insulator 1/2 turn Counter-Clockwise and pulling
outward.
• Withdraw the Lead from the short Cable Lead from the Positive Connection
Receptacle.
• Align the key of the brass ferrule with the notch of the receptacle at the 12:00
position, then insert the Lead onto the Negative ( - ) Connection Receptacle,
seat fully and rotate 1/2 turn Clockwise to lock.
• Insert and lock the Ground Clamp Cable into the (+) Receptacle.
INSTALLING THE SHIELDING GAS SUPPLY
BUILDUP OF GAS CAN INJURE OR KILL!
• Shut off shielding gas supply when not in use.
• Always ventilate confined spaces or use approved air-supplied respirator.
• Always turn your face away from valve outlet when opening cylinder valve.
CYLINDERS CAN EXPLODE IF DAMAGED!
Shielding gas cylinders contain gas under high pressure.
If damaged, a cylinder can explode. As gas cylinders are a
normal component of the welding process, use extra care
to handle them carefully.
• Protect compressed gas cylinders from excessive heat, mechanical shocks,
physical damage, slag, open flames, sparks and arcs. Keep away from any
welding or other electrical circuits.
• Install cylinders in an upright position by securing to a specifically designed
rack, cart or stationary support to prevent falling or tipping over.
• Never weld on a pressurized cylinder or explosion will occur.
• Use only correct shielding gas cylinders, regulators, hoses and fittings de-
signed for the specific application; maintain them and all related components
in good condition.
• Keep protective cap in place over valve except when cylinder is in use.
• Use proper equipment, procedures and have adequate help when moving or
lifting cylinders.
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 6
FIG. 7
Rotate 180° To Lock
FIG. 8
FIG. 9
9