Table of Contents
Advertisement
MIG WELDING SET-UP
AND OPERATION
SET UP FOR MIG WELDING
Installing the MIG Welding Gun
• Open the side door of the Welder and loosen the Torch Tensioner Wing
Screw located on the side of the brass, hex shaped member of the Drive
Motor Assembly (FIG 2).
• Plug the Brass Body End of the Welding Gun line into the designated
socket (FIG 3).
IMPORTANT NOTE: The Brass Body End must be fully seated against the
base of the drive assembly socket or gas may either leak or not be able to
pass through the connections to the end of the Welding Gun (FIG 4).
• Tighten the Torch Tensioner Wing Screw finger tight (FIG 3).
• Connect the Male Metal Plug to the Female Cannon Plug connection on
the front of the Welder (FIG 5).
• Set the Selector Switch [A] located on the Front Panel to the MIG Position
(FIG 1).
8
FIG. 2
FIG. 3
FIG. 4
FIG. 5
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com
Hide quick links:
Advertisement
Table of Contents
