Winegard AIR 360+ Manual page 10

Power Supply Installation – TV Antenna
WARNING: The power supply should be turned off when connecting cables.
Coaxial
port for
main TV
Step 1 – The power supply may be flush mounted in most standard electrical
boxes. To flush mount, cut a hole in the wall to fit the box. Run two #12 wires
between the wall plate and +12 VDC source, and route downlead cable to this
location.
Step 2 – Make a 12 volt connection from the RV to the power supply. Install
the supplied terminals on wires from +12 VDC source, and crimp the
terminals with an appropriate crimping tool.
Step 3 – Push the wires onto tabs on the back of the power supply. ("PWR"
and "GND" are also noted on the underside of the power supply electronics
board).
Step 4 – Connect the coax cable from the antenna to the "ANTENNA" port on
the power supply, and tighten until fingertight. Then, tighten ¼ turn more.
Step 5 – If hooking up the antenna to two televisions, connect a coax cable
from the "SET 2" port to the "Antenna In" port on the second television.
If hooking up a cable input, connect the cable input to the "CABLE" port on
the power supply.
Step 6 – Mount the power supply in wall with the provided screws.
Step 7 – Connect a coax cable from the coax port on the front of the power
supply to the "Antenna In" coax port on the main TV.
Step 8 – Press the "ON" switch on the front of the power supply, and check
that the wall plate indicator light is on.
This unit is equipped with a polyswitch, which will shut down +12 VDC if
there is a direct short between the antenna and power supply. The indicator
light will not light. Once the short is eliminated, the device will reset itself.
Indicator
light
On/Off
button
Antenna
port
Power
Ground
tabs
–9–
&
Set 2
port
Cable
port