Advertisement
4.6.
General operating instructions
Press the Power button (fig.1) to turn the borescope on.
4.6.1.
Press the Settings/Back button
4.6.2.
Select Advanced Settings, then press OK.
4.6.3.
Select Date and Time, then press OK. Use Left/Right and Up/Down buttons to set date and time, then press OK.
4.6.4.
Select Language, then press OK. Use left/right buttons to chose language. Confirm with OK.
4.6.5.
Select Colour or Black/white., then press OK. Use left/right buttons to select colour or black/white, then press OK.
4.6.6.
Select Format Media, then press OK. Choose No or Yes, then press OK.
NOTE: Pressing OK whilst yes is selected will erase all files from the micro SD card.
4.7.
To view firmwear version, select Help, then press OK.
4.8.
Live viewing
View on Display Screen or use RCA cable to view on external monitor.
4.8.1.
Adjusting Light: Press left button to dim and turn off light. Press right button to turn on light and increase brightness.
4.8.2.
Zooming: Press up button to zoom in, down button to zoom out.
4.8.3.
Flip Image: Press Flip image/trash can
4.9.
Capturing images
4.9.1.
Press the camera/video
4.9.2.
Camera mode: Press OK to capture image.
4.9.3.
Video mode: Press OK to start video.
4.10.
Playback and delete
Playback on display screen, external monitor, or another device.
4.11.
Display screen
4.11.1.
Press the Playback
4.11.2.
Press OK to view image or video. For video, press OK to start and stop.
4.11.3.
To delete file, press flip image/trash can
4.12.
External monitor
Connect borescope to monitor using an RCA cable, then follow 'display screen' instructions (section 4.11).
4.13.
Another device
Remove SD card to view files on another device.
When finished, press the power button to switch off and store in a cool, dry childproof location.
5. MAINTENANCE
5.1.
Battery removal/replacement
5.1.1.
To remove batteries, slide the battery compartment cover (fig.2) free and remove the battery carrier.
5.1.2.
Remove the dead batteries and replace with fresh.
WARNING: only use rechargeable cells with this borescope: the use of non-rechargeable cells could lead to fire or explosion.
‰
5.1.3.
Replace the battery carrier and slide the battery compartment lid back on.
5.2.
Cleaning
5.2.1.
DO NOT use abrasive or solvent cleaners. Use a mild detergent on a soft cloth, taking care not to put excessive pressure on the
display screen.
6. TROUBLESHOOTING
Problem
Display is on, but does not show image.
1) Light is dim at maximum brightness.
2) Display turns itself off.
3) Borescope will not turn on.
© Jack Sealey Limited
to enter setup.
button to flip image horizontally and vertically.
button to toggle between camera and video modes.
button to use JPG and AVI files. Use left/right and up/down buttons to navigate through files.
button, select File/delete, then press OK.
1) Cable connection loose.
2) Imager probe is dirty.
1) Low battery.
2) Low battery.
3) Low or dead battery.
Original Language Version
Possible Causes
Likely Solutions
1) Check cable connection.
2) Clean imager probe.
1) Charge battery.
2) Charge battery.
3) Charge battery; if it won't take a
charge, replace battery.
VS8230,VS8231,VS8232
Issue: 1 - 27/11/17
Advertisement
