Related Manuals for MULTIQUIP HBC19B
Summary of Contents for MULTIQUIP HBC19B
- Page 1 SAFETY AND OPERATIONS INSTRUCTIONS FROM: PLEASE READ THIS INFORMATION CARFULLY PRIOR TO OPERATING EQUIPMENT...
-
Page 2: Safety Message Alert Symbols
CAUTION You CAN be INJURED if you DO NOT follow these directions. PAGE 4 — HBC19B/HBC25B REBAR CUTTER • OPERATION AND PARTS MANUAL — REV. #1 (03/07/12) -
Page 3: Rules And Regulations
KEEP bystanders, children, and visitors away while operating the equipment. Distractions can cause loss of control. HBC19B/HBC25B REBAR CUTTER • OPERATION AND PARTS MANUAL — REV. #1 (03/07/12) — PAGE 5... - Page 4 If they are not, server damage nameplate before applying power. to the unit, particularly to the power cord could occur. Personal injury may also occur. s t l PAGE 6 — HBC19B/HBC25B REBAR CUTTER • OPERATION AND PARTS MANUAL — REV. #1 (03/07/12)
-
Page 5: Specifications
4 pieces (M4, 5, 6, 8) 0.55 x 0.67 in (14 x 17 mm) Open-End Wrench 0.67 x 0.75 in (17 x 19 mm) 0.94 in (24 mm) HBC19B/HBC25B REBAR CUTTER • OPERATION AND PARTS MANUAL — REV. #1 (03/07/12) — PAGE 7... -
Page 6: General Information
All parts are machined cutter blade jams and stops during cutting of a rebar. to tight tolerances for maximum performance. PAGE 8 — HBC19B/HBC25B REBAR CUTTER • OPERATION AND PARTS MANUAL — REV. #1 (03/07/12) - Page 7 5. ON/OFF Switch - Starts the cutting of the rebar when the trigger switch is squeezed. When released, cutting is stopped. Do not release release switch until the rebar is completely cut. HBC19B/HBC25B REBAR CUTTER • OPERATION AND PARTS MANUAL — REV. #1 (03/07/12) — PAGE 9...
-
Page 8: Operation
1. Rotate the return valve half a turn in the Refer to Maintenance section for details. counterclockwise direction with the allen wrench (no. 4) supplied with the unit. See Figure 3 for location. PAGE 10 — HBC19B/HBC25B REBAR CUTTER • OPERATION AND PARTS MANUAL — REV. #1 (03/07/12) -
Page 9: Replacing Carbon Brushes
It is also recommended that the brushes be replaced 6. For the HBC19B, replace cover and tighten 2 bolts. after 200 hours of use. HBC19B/HBC25B REBAR CUTTER • OPERATION AND PARTS MANUAL — REV. #1 (03/07/12) — PAGE 11... -
Page 10: Maintenance
9. When cutting is complete, filling procedure is done. FILL WITH OIL WARNING Unplug unit from power source before troubleshooting. Figure 8. Oil Fill PAGE 12 — HBC19B/HBC25B REBAR CUTTER • OPERATION AND PARTS MANUAL — REV. #1 (03/07/12) - Page 11 . r e e t t z i r i v r t t u l l i . y t HBC19B/HBC25B REBAR CUTTER • OPERATION AND PARTS MANUAL — REV. #1 (03/07/12) — PAGE 13...