Download Print this page

Kenwood TTM020A Series Instructions Manual page 4

Hide thumbs Also See for TTM020A Series:

Advertisement

before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your toaster.
WARNING: THIS APPLIANCE
MUST BE EARTHED.
Important – UK only
The wires in the cord are coloured
as follows:
Green and Yellow = Earth,
Blue = Neutral,
Brown = Live.
The appliance must be protected by
a 13A approved (BS1362) fuse.
Note:
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
This appliance conforms to EC
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
Use the carriage lever to lift the toast
to Peek & View™ at any time
without cancelling the toasting cycle.
before using for the first time
1 Clip excess cord into the cord
storage clips in the base
Operate the toaster once on a
medium setting without bread. (The
lever will not stay down unless the
toaster is plugged in).
As with all new heating elements,
your toaster may emit a slight
burning smell when it is first
switched on. This is normal and not
a cause for concern.
key
to use your toaster
1 Plug the toaster into the power
supply.
2 Move the browning control to the
desired setting. Use a low setting
for light toasting and for thin or dry
bread.
3 Insert the bread, muffins, bagels etc.
4 Lower the lever until it locks
'cancel' button will illuminate. (The
lever will not stay down unless the
toaster is plugged in).
To toast frozen bread, move the
browning control to the defrost
position
Use the carriage lever to lift the toast
to Peek & View™ at any time
without cancelling the toasting cycle.
To stop toasting during the cycle,
press the 'cancel' button, the toast
will pop up and the 'cancel' button
light will go off.
5 Your toast will pop up
automatically, to raise it higher, lift
the lever.
hints on using your
toaster
Select a lower setting for light
browning, for toasting one slice only
.
or for dry bread.
When toasting a single slice of
bread, you may notice a variation in
toast colour from one side to the
other - this is normal.
4
removable warming rack/toast rack
warming rack handle
Peek & View™ carriage lever
browning control
cancel button with indicator light
crumb tray
cord storage
.
. The

Advertisement

loading

This manual is also suitable for:

Ttm060 seriesTtm02