Folding The Handle - Toro Recycler 21762 Operator's Manual

1. Washout port
6. Turn the water on.
7. Start the engine and run it until the clippings no
longer come out from under the machine.
8. Shut off the engine.
9. Shut off the water and disconnect the garden
hose from the machine.
10. Start the engine and run it for a few minutes to
dry the underside of the machine to prevent it
from rusting.
11. Shut off the engine, remove the electric-start
button (if equipped), and allow the machine to
cool before storing it in an enclosed area.

Folding the Handle

WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Remove the electric-start button (if equipped);
refer to Figure 21.
Figure 20
g033492
1. Electric starter
2. Remove and save the 2 handle knobs and 2
carriage bolts from the handle brackets
22).
Important:
of the handle knobs as you fold the handle.
1. Handle knob
3. Fold the handle by rotating it forward
18
Figure 21
2. Electric-start button
Route the cables to the outside
Figure 22
2. Carriage bolt
g035929
(Figure
g032869
(Figure 23).