Using The Self-Propel Drive; Shutting Off The Engine - Toro Recycler 21762 Operator's Manual

Starting the Engine Using the Recoil-Start Handle
1. Hold the blade-control bar against the handle (A of
2. Pull the recoil-start handle (B of
Note:
When you pull the recoil-start handle, pull it lightly until you feel resistance, then pull it sharply.
Allow the rope to return to the handle slowly.
Note:
If the machine does not start after several attempts, contact an Authorized Service Dealer.

Using the Self-Propel Drive

To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the machine will automatically keep pace
with you (Figure 15).
Note:
If the machine does not freely roll backward
after self-propelling, stop walking, hold your hands
Figure
Figure 15
Figure 13
Figure 14).
14).
Figure 14
in place, and allow the machine to roll a couple of
centimeters (inches) forward to disengage the wheel
drive. You can also try reaching just under the upper
handle to the metal handle and pushing the machine
forward a couple of centimeters (inches). If the
machine still does not roll backward easily, contact an
Authorized Service Dealer.

Shutting Off the Engine

Service Interval: Before each use or daily
To shut off the engine, release the blade-control bar.
Note:
Remove the electric-start button (if equipped)
whenever you leave the machine.
Important:
g233423
bar, the engine should shut off and the blade
should stop within 3 seconds. If they do not, stop
using your machine immediately and contact an
Authorized Service Dealer.
14
When you release the blade-control
g239637
g233422