Pre-Installati on Instructi ons
The manufacturer has preset the water treatment unit's sequence of regeneration cycles and cycle times.
THE DEALER SHOULD...
•Read this page and guide the installer
regarding day override and time of
regeneration settings prior to installation .
GENERAL OPERATING DISPLAYS & NAVIGATION
During normal operation, the default user displays are "time of day" and "gallons per minute" . Flow rate, capacity remaining, and days to a
regeneration are optional displays . For more explanation, consult the "operating displays and maintenance section" . Pressing the NEXT button on a
general operating screen will cycle through the available operating displays .
In any screen other than a general operating display, the NEXT button will proceed to the next step, the REGEN button will return to a previous step,
and the CLOCK button will return to the general operating displays . Any changes made prior to the exit will be incorporated . If no buttons are pressed
within five minutes, the display will return to the general operating displays .
DOUBLE REGENERATION
Two generations within 24 hours are possible with a return to the preset program . To initiate a double regeneration:
1 . Press the REGEN button once . "REGEN TODAY" will flash on the display .
2 . Press and hold the REGEN button for three seconds until a regeneration begins .
Once the valve has completed the immediate regeneration, the valve will regenerate once more during the preset time .
Hague Filter Owner's Manual
THE INSTALLER SHOULD...
•Program installer settings including day
override and time of regeneration .
•Read Operating Displays and Maintenance
section .
•Set the time of day .
•Read Power Loss and Error Display section .
•Ensure that system and installation are in
compliance with all state and local laws and
regulations .
THE HOMEOWNER SHOULD...
•Read Programming Procedures section .
•Read Operating Displays and Maintenance
section .
3