Mounting; Transport And Storage - Siemens Simatic 6DL2804-0 Series Installation Manual

Mounting

NOTICE
• When installing control and measuring devices in the Ex enclosure, keep to the
• All control and measuring devices installed in the enclosure must be separately certified
• Run the tests prescribed in the relevant national regulations for the installed control and
Note
• Install and operate the distributed I/O device in hazardous areas according to the
• Assembly, installation, commissioning and maintenance may only be performed by
• The devices and installed components must only be used for their intended purpose.
4.1

Transport and storage

Pack and store the enclosure for transport or storage so that there can be no undue strain on
the enclosure, particularly on its top cover. If there is too much strain on the top cover of the
enclosure, this can damage the seal.
The transport locks between cover and enclosure are no longer needed after the assembly
of the enclosure.
Wall-mount enclosure 6DL2804-0xxxx
Hardware Installation Manual, 08/2009, A5E00378691N-02
instructions in the relevant product descriptions and the technical specifications in the
data sheets.
for the relevant hazardous zone.
measuring devices.
specifications of the EC-type examination certificate according to ATEX and these
operating instructions or the examination certificate valid in your country.
qualified personnel.
4
15