Advertisement
Install the Shade
2A
FIXTURE BASE
SHADE
CAUTION: Improperly aligning the pegs before
rotating the shade into place may cause damage to
slots. Make sure the shade sits flush before rotating.
Align the pegs on the shade with the keyed slots on the
1
fixture base, push the shade up evenly, making sure it
sits flush on all sides.
2
Carefully rotate the shade into position.
2B
THUMB SCREW
3
Locate the small threaded hole on the top side of the
shade.
Screw the thumb screw into the shade to secure it in
4
place.
SLOT
1
PEG
1
FIXTURE BASE
SHADE
Install the Trim Accessories(Lance only)
NOTE: The Lance 13 ships with three trim accessories.
The trim accessories are not included with the Vance.
3A
1
Attach the trim accessories to the rim of the shade.
Imbedded magnets will allow the accessories to snap
into place.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie,
www.techlighting.com
© 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
2
TRIM ACCESSORY
IL
60077
847.410.4400
A Generation Brands Company
Advertisement
