Niigata seiki LEVELNIC DL-S3 DL-BW Instruction Manual

LEVELNIC DL-S3 Wireless Adapter DL-BW
Thank you for purchasing the DL-BW Wireless Adapter for LEVELNIC model DL-S3.
Please read this instruction manual thoroughly before use to insure proper operation and long service.
■ OVERVIEW
Display unit for LEVELNIC DL-S2W (wireless digital gauge,) also providing remote 0-Cal, and 1/2-Cal buttons.
Can used as display for other LEVELNIC gauges with RS-232C output, (without remote 0-Cal or 1/2-Cal functionality.)
■ FEATURES
・Cable free connection makes measurements easier and improves work efficiency.
・Long range of 50 to 100m wireless connection.
・Receiver and Transmitter are paired so multiple systems can be used at same time without interference.
・Can be mounted directly to LEVELNIC, or as stand-alone unit with adaptable mounting bracket design.
・Preset communication settings (pairing, etc. ) so system is ready for immediate use.
■ COMPONENT NAMES
① Signal Adapter Unit
② Battery Compartment
Requires 6x AA batteries.
Please insert with polarity as indicated.
③ Adapter Power Switch
④ Power Status Light
The two LED bulbs indicate power status:
・2 lights . . Normal operation
・1 light . . . Battery level low
System can still be used, but please prepare to replace batteries soon.
・Off . . . . . . Battery replacement required
Battery voltage is too low for operation.
Please replace batteries.
⑤ Data Cable
Connects to LEVELNIC Data Out Jack.
⑥ Transmitter
Label on transmitter shows a 4 digit number: "SK****-S. This will pair with
matching label on receiver: "SK****-PC" for direct communication.
⑦ Transmitter Slide Switch
Since the transmitter power is linked to the adapter unit power,
always keep the this switch in the ON position.
⑧ Mounting Bracket
When shipped, the mounting bracket is attached to the Adapter Unit for stand-alone set-up.
The bracket can be relocated and mounted on the side of the Adapter Unit for
attachment to the underside of the DL-S3 Base.
⑨ Mounting Screws
These two screws mount the bracket to the adapter unit. When changing bracket
position, remove the screws and reattach in new position.
⑩ DL-S3 Mounting Screws
Special thin head screws for mounting to DL-S3 Base without protruding and
interfering with measurement surface.
When attaching screws, use enough force to prevent rattling, but do not over tighten.
⑪ Receiver
Label on receiver shows a 4 digit number: "SK****-PC". This will pair with
matching label on transmitter: "SK****-S for direct communication.
⑫ Receiver Power Jack
Receiver is powered through the PC USB port, so always keep this switch in the ON position.
⑬ Receiver Power Jack
Connects to computer using USB power cable.
⑭ USB Power Cable for Receiver
Connects to computer USB port to power the Receiver.
If cable is not long enough to reach Receiver when plugged into RS-232C port, a
commercially available cable can be used.
Instruction Manual
⑥
⑦
④
③
⑧
⑪
⑫
NIIGATA SEIKI CO., LTD
①
【Stand Alone Set-up】
②
⑧
⑤
【Ready for Mounting】
⑨
⑩
⑭
⑬