Product Presentation; Mounting Kit - CDVI SOLARKPW Installation Manual

INSTALLATION MANUAL
SOLARKPW-SOLARKPB
Dual Technology Digicode

1] PRODUCT PRESENTATION

Dual technology: Proximity reader and/
or Digicode keypad.
®
Wiegand 26, 30 or 44 bit.
Sensitive touch keypad.
PCB sealed in epoxy.
Audible and visual feedback.
Version available in: white or black.
WEEE
2] REMINDERS AND RECOMMENDATIONS
Operating mode
SYSTEME KEYPAD PROXIMITY
TELACCESS 4
TERENA 4
CENTAUR 4
ATRIUM 4
Cable
- Programming your installation before installing
products on site.
- The distance between a CENTAUR and ATRIUM
controllers or an INTBUSW reader interface
should not exceed more than 50 meters.
- Make sure that the cable is not near by a high
voltage cables (ex: 230 V AC).
- Recommended cable 2 twisted pairs
SYT1 0.8MM (AWG 20).

3] MOUNTING KIT

Foam seal
SOLARKP RANGE 1
cdvi.com
10
cdvigroup.com
/Proximity reader - Wiegand
®
Certification FCC CFR 47
IP53
part 15 compliance
MODE
DUAL TECHNOLOGY
4 4
-
4
4 4
-
4
3x30
TF screw Plastic anchor
2
Technology: 125 kHz.
Multi card protocol reader - Marin/HD.
Input voltage: 12V dc.
Consumption: 150mA.
-25°C to +70°C
Back EMF protection
To secure the system from back electromagnetic
fields do not forget to mount the varistor in parallel
on the lock terminals.
Security Advice
- For security reasons, change the factory default
master code.
- When selecting a master code and user code
avoid simple codes (example : 3 4 5 6 7).
Mounting recommendations
Mount the keypad on a flat surface to avoid
any vandalism and to insure the best mounting.
Recommended power supplies
ARD12 & BS60. These products must be powered
in 12Vdc and the power supply should be
certified EN60950-1:2006/A11:2009 standards
and should be designed to be a low power supply
source.
S5
TORX bit
®
2 1
CE Certification
3x8
TORX screw
®
1
EN