Table of Contents
Advertisement
Charge and power on/off instructions
Charging
Only the car charger included in the box can be used with 5V 1.5A output. If the current is
less than 1.5A, or the voltage different from 5V, the device could be damaged or could not
work properly.
Connect one end of the car adapter to the USB connector of the camcorder mount.
Plug the other end of the car charger to the cigarette lighter socket of your vehicle. Once the
vehicle engine is started, the camcorder automatically powers on.
Attention: in some vehicles the cigarette lighter has no outage after the vehicle turns off, this
means that the automatic turning on/off is not possible. Therefore the camera must be manually
switched on/off.
Please make sure to charge the device at least two hours before using it: if the battery is
completely discharged, the camera will return to default settings.
Note
The red led lights up while the battery is being charged (a complete recharge takes about 120
minutes). Then the led will turn off.
Auto power on/off
When used as driving recorder, it is required to turn ON the "Loop Recording" and "Power
ON record".
In this way, if the camera is connected to the car charger when the vehicle engine is turned
on, it will start recording video; when the vehicle engine is turned off, the data will be saved,
and the device will automatically shutdown.
Attention: in some vehicles the 12V plug does not switch off the power when the engine is turned
off, therefore the automatic turning on and off cannot be done. You have to do it manually.
Manual power on/off
Shortly press the Power button to turn on the device: the red led will turn on
Enter the video mode, keep pressed the Power button: the red led will switch off.
Attention: in case of very low battery, the camera will emit an acoustic sound and then switch off.
8
Advertisement
Table of Contents
