OMAS Air-Fi AFT7 Installer And User Instruction Manual page 8

!
Remove the screws fixing the display
support and rotate it of 180°. Pay attention to
place in the correct position the electrical
cables.
!
Position the display back by using the
screws previously removed. Rotate the indoor
unit of 180°, by maintaining the air exit on the
left side.
!
By maintaining the front panel with the brand
plate in the lower part, insert it back by rolling
it from right to left side.
!
Both the pipes located in the rear part of the
indoor unit must be rotated up to 180°:
!
Remove the 4 screws (A) that fix the plastic
protection covering the cooling circuit.
A SPECIAL ATTENTION SHOULD BE PAID
DURING THE FOLLOWING STEPS :
!
Take the indoor unit pipes out of 15°
(PHASE 1)
!
Rotate the terminal part, gently, up to 180°,
avoiding possible bendings on the curve
(PHASE 2) by maintaining the pipes blocked
in the (B) position.
The internal unit is equipped with condense
drainage connection option both on the upper
and lower part. If the air exit position should
be changed, the condense drainage position
must be modified too : take the pipe and the
plug positioned on the drainage connection off
and then invert their position.
!
Put all the removed platics parts back to their
original position and fix them with the screws.
!
Position the indoor unit on the upper part of
the wall mounting bracket and rotate it up to
45°.
After these operations the air conditioner is
ready to be installed with air exit located on its
left side.
ENGLISH -7-
(A)