Cleaning The Focusing Screen; Removing The Battery Compartment; An Attached Motor; Removing The Camera Back - Leica DIGITAL-MODUL-R Instructions Manual

Cleaning the focusing screen

Dust particles can be removed using the brush sup-
plied. It is recommended that you place the brush in
the hole provided in the container and then move the
focusing screen over the hair of the brush using the
tweezers.
More severe dirt and fingerprints can be removed in an
ultrasonic bath by an optician or by the Leica Camera
AG Customer Service.
Note: Use a clean fresh ultrasonic bath; hold focusing
screen with the tweezers and immerse for 3–4 minutes,
do not simply place in the bath.
Important: Do not attempt to clean a focusing screen
with lens paper or a cloth - this can cause such severe
damage to the surface that the focusing screen can no
longer be used.
Then rinse the focusing screen with distilled water in
the ultrasonic unit for 3–4 minutes.
Notes:
• If non-distilled water is used, marks can be expected.
• The ultrasonic bath and distilled water should not be
heated.
When removing the focusing screen, lightly shake off
the residual water and place in the container to dry.
74 / Detailed guide / Preparation

Removing the battery compartment/

an attached motor

Like the Motor-Winder-R8/R9 / Motor-Drive-R8/R9,
the power unit for the Digital-Modul-R has its own inte-
grated grip section. The battery compartment or any
motor attached must therefore be removed from the
camera.

Removing the camera back

1. Open the camera back.
2. Place slider B on the inside of the camera back, as
shown in Figure 1. For correct guidance, the grooves
in the slider must be aligned with the vertical strip to
the right of the axis (arrow).
3. Press the slider and thus the moving upper joint pin
on the back downwards. The back is thus unlocked
and can be
4. tilted (Figure 2) and removed.
To attach the camera back, follow this procedure in
reverse order.
1
2