Icon Server Settings - Barco VRWF-3200 System Installation Manual

Setting
Mode
Computer Name
Master as Slave source
Baud rate
RS 232 address
For the Slave :
Setting
Mode
C
AUTION
the VR Workroom system.
Note : Mono in VR Workroom mode
In the Mono in VR Workroom mode both projectors are switched on but only one projector is projecting an image.
The projector projecting the image is selected based on the projector's lamp runtime (the shortest lamp runtime is selected).
In fact the other projector is powered up i.e. all the electronics are powered up except for the lamps (this is
necessary to allow VR Workroom functionality).
How to check the settings ?
1. On the master projector, Go to Start/Control Panel
2. Select Appearance and themes/Barco Desktop integration
A dialog box is displayed
3. Open the Mode tab
8.1.2

iCon Server settings

iCon server settings
To allow communication between the master and the slave projector both servers have to be ON, even if the projectors are in the
Standby state :
Setting
Projector Standby state
Projector ON state
How to access the iCon Server settings ?
1. Press MENU to activate the Tool bar
2. Press → to select Installation
3. Press ↓ to Pull down the menu
4. Use ↑ or ↓ to select iCon Server settings (image 8-3)
5. Press ENTER
R5976989 BARCO VR WORKROOM 22/09/2006
Default value
Master in VR Workroom
VRslave
L3 DVI
115200
2
Default value
Slave in VR Workroom
:
Never change these settings ! Changing these settings will not guarantee proper functioning of
Default value
ON
ON
Note
see note below on Mono in VR Workroom
Mode
can be adapted to meet local LAN policies
can be different if input hardware
configuration is changed
Must be same as the value set in the slave
projector. See "Projector communications
settings" below.
Must be same as the value set in the slave
projector. See "Projector communications
settings" below.
Note
see note below on Mono in VR Workroom
Mode
Note
Must always be ON !
Must always be ON !
8. Setup
37