Safety 1st Grow and Go 3-in-1 Instructions Manual page 13

5. Pull Headrest Pad Off
of Bottom of Headrest
As Shown
Remove headrest pad from shell.
6. Undo Fasteners on Seat
Pad As Shown
7. Pull Pad Off of Sides and
Bottom of Shell
8. Pull Pad Down and
Off of Bottom of
Harness Holder
Pull up to remove completely.
19
4358-6653 Grow and Go 3 in 1.indd 25-26 4358-6653 Grow and Go 3 in 1.indd 25-26
9. From the Top, Pull Pad
Off of Shell
WARNINGS:
Do not use child restraint without the
seat pad. Failure to do this can result in serious injury or
death.
Cleaning Pad and Accessories
Machine wash all pieces separately with cold water on a gentle
cycle. Make sure harness covers are closed so fastening strips
are not exposed. Do not use bleach. Tumble dry separately for
10-12 minutes on low heat. Remove immediately.
Cleaning Harness Strap
Spot clean using warm sudsy water and damp cloth.
Replacing Pad
Adjust the headrest to the highest position. Starting from the
bottom, gently pull headrest pad onto headrest. Place elastic
straps on headrest pad around headrest/harness adjustment
levers. Slide harness straps into slots in pad. Attach fasteners.
Starting from bottom of child restraint, slip pad on shell. Pull
harness adjustment strap through pad. Wrap pad around bot-
tom and sides of shell. Push harness holders through slots in
pad. Push pad behind headrest. Wrap around the top of shell.
Slide harness straps into slots in pad. Attach fasteners.
20
4/15/15 8:48 AM 4/15/15 8:48 AM