Table of Contents
Advertisement
MicroCSU/DSU Cards and MicroRacks
Prior to installation, you will need to examine the rear card you have selected and
make sure it is properly configured for your application. Each rear card is
configured by setting straps located on the PC board.
To configure the rear cards, you must set the configuration straps. Figure 19 shows
the orientation of these straps. Each strap can either be on pegs 1 and 2, or on
pegs 2 and 3. Sections 4.3.1 and 4.3.2 describe the strap locations and possible
settings for each rear card.
1
2
3
1
2
3
1
2
3
Figure 19. Orientation of interface card straps.
30
Advertisement
Table of Contents
