METALSUB XRE 700 Manual

General:
- After each dive, rinse the dive light under running water to remove all traces of dirt, sand and salt.
- Dry the charging sockets after each dive, we suggest blowing in air with an airgun or straight from the cylinder.
- Avoid physical impact.
- The metalsub XRE700 is designed for use as underwater lighting application.
When used above water we recommend to use the light only in dim position to avoid overheating.
Warranty
The Metalsub torch warranty will start on the date of purchase. The warranty period is 24 months and will only
count when the torch has been used in the way the manufacturer advises and has explained in the outlines.
During this warranty period we will repair all problems that are caused by manufacture related mistakes.
We will take no responsibility for damage that is done through misuse or normal wear and tear of the Metalsub dive
light for whatever reason. There is no warranty on the o-rings. The warranty period of the battery pack is 12 months
from purchase date. Until 36 months from purchase we offer a fair settlement.
We will give no warranty when any person has carried out any repair or rebuilding on our products by themselves!
All goods being returned for warranty must be returned prepaid, sufficiently packed under the owners risk to your
Metalsub dealer.
Technical information XRE 700
Material
Size (d x l)
Weight above water
Weight under water
Hyperbaric pressure test
Standard light power
Reflector
Battery pack
Capacity at 100% power
Capacity at 33% power
(temperature 20 C)
Securities
Electronic circuit
Charger
*
In accordance with American Miliary Standard MIL-A-8625-E type 3 class 2. Also the coating is impregnated with Teflon.
Metalsub® Nederland, 2009
Aluminium, anodised, Teflon coated *
52 mm x 240 mm
550 gram
250 gram
25 Bar
12 Watt LED
Angle 10 (spot)
Li-Mangan 7,2 Volt – 2,6 Ah
Appr. 110 minutes
Appr. 250 minutes
- mechanical thermal protection 60 C
- overpressure valve for any battery gas leakage
- lock button on switch
Variable light power 0-33-100%
Deep discharging protection
SOS-signal
Battery capacity indication
- Beacon signal - one short flash per second
- Strobe signal - four short flashes per second
- S.O.S. signal - 3x short, 3x long, 3x short flashes
MP500 (standard)
External charging by two charging plugs
Standard and only suitable for XRE700
Automatic switch to pulse charging
charge time 5 hour
Standard supplied with AUS/EURO/USA/UK mains plugs
Rights reserved for technical changes
Manual
METALSUB - HANDLAMP
XRE 700
®
Nederland
09