Getting Started; About Drivers; About Upgrades - Schiit True Multibit Autonomy Bifrost Owner's Manual

GETTING STARTED

1. Connect Bifrost 2 to your source and your amp
or preamp. You'll need RCA-to-RCA or XLR-to-
XLR cables to connect the Bifrost to your preamp
or amp, as well as a digital cable or cables
(coaxial, Toslink, or USB) to connect your source
or sources.
2. If you are using USB, use a good, short cable.
You need to use a 2M or less, true USB 2.0 rated
cable at a minimum. The one you found covered
in dust at the back of the closet may not cut it,
but any new USB cable from a reputable cable
manufacturer should do just fine.
3. If you are using a computer source, ensure it
is set to output to the Bifrost. Sometimes PCs
and Macs get confused and want to use internal
speakers, or your powered USB headset, or
whatever.
4. Select your source using the button on the
front panel. And enjoy your music!

ABOUT DRIVERS

Schiit's Unison USB™ is UAC2 compliant, which
means it does not need drivers on any modern
operating system.

ABOUT UPGRADES

Bifrost 2 is firmware upgradable via a MicroSD
card slot, and hardware upgradable via slide-in
Input Card and Analog Cards.
Firmware upgrades, when available, will be
posted at schiit.com/firmware, together with
information on how to write to a microSD card.
Hardware upgrades, when available, will be
purchasable on the Schiit site, in the Upgrades
section. These upgrades simply slide in to the
appropriate slot on the back panel, so you won't
need to send it in for upgrade.
If you'd like to be the first to know about
upgrades as they become available, sign up
on the SPAM link on our site.