Download Print this page

Battery Installation; Lcd Display; Symbols And Annunciators - Sealey TM101 Instructions

Professional digital multimeter ncvd 7 function

Advertisement

this symbol indicates that a device is protected throughout by double insulation or reinforced insulation.
Warning! NEVER apply voltage or current to the multimeter that exceeds the specified maximum as shown below:
function
V Ac
V dc or V Ac
mA dc
A dc
10A 250V fast acting fuse (30 seconds max every 15 min.
resistance, continuity
1.4.

BAtterY instAllAtion

Warning! to avoid electric shock, disconnect the test leads from any source of voltage
before removing the battery cover.
disconnect the test leads from the meter.
open the battery cover by loosening the two screws using a Phillips head screwdriver.
remove old battery (if applicable) and insert the new battery into battery holder, observing
the correct polarity. fit the battery cover back in place. secure it with the screws.
Warning! to avoid electric shock, do not operate the meter until the battery cover is in
place and fastened securely.
note! if your meter does not work properly, check the fuses and battery to make sure that
they are still good and that they are properly inserted.
2. introduction
High precision multimeter. conforms with en61010-1 cAtiii 600V safety requirements for
electrical equipment for measurement,
control, and laboratory use. features non-contact Ac voltage detection function.
double moulded housing with soft grip case and large display for ease of use. the housing
has practical storage for probes and lead and has an integral upright stand for use on the
workbench. measures:
• AC and DC Voltage
• DC Current
• Resistance
• Diode Test
• Continuity Buzzer
• Non Contact Voltage Detection (NCVD)

1. lcd display

2. function switch
3. 10A Jack
4. com Jack
5. Positive Jack
6. non contact Voltage (ncV) Warning light

sYmBols And AnnunciAtors

•)))
Continuity Test
diode test
µ
micro (Amps)
m
milli (Volts, Amps)
k
Kilo (ohms)
Ohms
Vdc
Volts direct current
VAc
Volts Alternating current
Adc
Amps direct current
BAt
Battery test
© Jack sealey limited
input limits
maximum input
600V dc/Ac
600V dc/Ac,200V rms on 200mV range
200mA 250V fast acting fuse
250V rms for 15sec max
Original Language Version
REMOVE SCREWS
TO ACCESS
BATTERY AND
FUSES
6
1
2
3
4
tm101 | issue 3 12/10/16
5

Advertisement

loading