FCC & IC STATEMENTS
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment. This
device complies with FCC and Industry Canada RF radiation exposure limits
set forth for general population (uncontrolled exposure). This device must not
be collocated or operating in conjunction with any other antenna or transmitter.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d'lndustrie Canada applicables
aux appareils radio exempts de licence. t:exploitation est autorisee aux deux
conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur
de
l'appareil
doit
accepter
meme si le brouillage est susceptible d'en compromettre le fonctionnement.
2
REGULATORY STATEMENTS
tout
brouillage
radioelectrique
CE STATEMENT
1418
Aegex Technologies LLC, Flatiron Building, 84 Peachtree Street NW
Atlanta, GA 30303 USA hereby declare, under its sole responsibility that the
product aegex10
Intrinsically Safe Tablet is in conformity with the
TM
relevant European Union harmonization legislation:
EMC Directive 2014/30/EU,
Low Voltage Directive 2014/35/EU,
Radio Equipment Directive (RED) 2014/53/EU
Restriction of Hazardous Substances (RoHS) Directive 2011/65/EU.
COUNTRY SPECIFIC APPROVAL DATA:
South Africa
– ICASA TA-2015/2247 approved
Oman
– TRA R/2983/15; D090016
Qatar
– ictQATAR Type Approval Reg. No. : CRA/SA/2015/R-5227
Importer No.: C.P/C.R. 41570
Australia -
RCM logo can be found by pressing Windows button/ Settings/
System / About/ System info. That is part of the Aegex Image.
Singapore - IMDA standard info
IMDA Electronic compliance labelling can be found by pressing Windows
button/Setting/System/About/System info. Dealer's Licence No. DA103861
That is part of the Aegex Image.
Country Specific labels are visible in the battery compartment, after the removal
of the battery.
subi,
Intrinsically
Safe
Solutions
by Design
Need help?
Do you have a question about the 10 and is the answer not in the manual?
Questions and answers