Advertisement
Thank you for purchasing the Ampino mono power amplifier.
We hope that you will enjoy it for many years.
For any questions or comments, or if we can assist you or support you in any way, please
don't hesitate to contact us.
Please read the following instructions before using this product.
Unpacking
Shipping boxes have been designed to protect their contents and special care has been
taken to prevent damage under normal shipping conditions. Mishandling should be
evident upon inspection of the carton shipping box. If damage is found after visual
inspection, document the damage with photographs and contact the transport carrier and
Dayens immediately.
Placement
Ampino is designed for use inside homes.
It must be protected from the temperature extremes.
Avoid placing the unit in extremely hot locations such as near radiators or other heating
units or in a place subject to excessive dust, mechanical shock and direct sunlight.
Device should not be placed on surface that may block the top or bottom ventilation
openings. Never block ventilation openings on top of the device.
Make sure that device has normal air flow for cooling purposes.
Device is attended to work in horizontal position only.
Do not place heavy objects on the component.
Its location among the user's audio components is not critical.
Installation and Setup
Connect speaker cables to rear speaker terminals; there is one pair per amplifier.
You can use terminated (bananas, spades) and un-terminated cables (bare wire).
Please make sure that cables aren't shorted at speakers end. Speaker cables should be
hand tightened down at the speaker output terminals, without excessive force.
Ampino is attended to work with most loudspeakers with impedance between 4 and 16
Ohm.
For preamplifier or source (with volume control) connection you can use any RCA
(unbalanced) interconnect cables, recommended length is between 0,5 and 1m.
The choice of a high quality interconnect and speaker cables is recommended for best
sonic result.
For maximum safety we suggest that the power cord should be the last cable installed on
your amplifier.
Advertisement
