Advertisement
Available languages
Available languages
INSTALLATION AND FRAMING INSTRUCTIONS
Locate studs as required. Ensure roughing-in dimensions are proper, plumb and square. Access to Pump/Motor may be made
through the access opening in the apron panel. It is strongly recommended that an additional opening be provided for access to
the drain components.
NOTE: The apron may be used as the primary access opening.
1. As shown in Fig. 1, mark the position of the underside of the deck by tracing a line onto the studs at the height indicated,
using a level or other suitable straight edge.
2. With the top of the stringer touching the traced line, attach the stringer to the studs.
3. Install drain components to the whirlpool or bath following the manufacturers instructions. See the roughing-in drawing for
suggested opening size and location dimensions.
4. THIS BATH MUST BE SUPPORTED ALONG ITS ENTIRE BOTTOM. We recommend the use of mortar as bedding material
(sand is not recommended). Apply enough bedding to support the complete bottom of the bath. After the bedding has been
poured, and before it sets, position whirlpool or bath within recess until the rim is leveled against the leveling stringers (see
"TYPICAL RECESS INSTALLATION") shown below. The rim of the bath MUST NOT support weight. Allow the bedding
material to completey harden before applying weight to the rim or bottom of the bath. Any finish material such as tile or wall
board must be self-supporting if it contacts the deck of the bath.
FIG. 1
19-3/4
(502mm)
TYPICAL RECESS INSTALLATION
19-3/4"
(502mm)
61-1/16"
(1526mm)
LEVELING
STRINGERS
34" TYP.
(864mm)
SUGGESTED WHIRLPOOL/BATH INSTALLATION METHOD
Waterproof Dry Wall
or Cement Board
Finished Wall
Leveling Stringer
1 x 3 (25 x 76mm) WOOD
SECURE THE BATH TO THE STUDS AS SHOWN FOR
WOOD OR STEEL STUD CONSTRUCTION.
(2)
Stud
(Wood or Steel)
Sealant
Tub
752561-100 Rev. F 1/19
Advertisement
