Remote; Getting Started; Deciding On Location; Rubber Feet - Monitor Audio ASB-10 Owner's Manual

Remote

1. Standby
Used to put the ASB-10 in and out of standby mode.
2. Volume Up
Used to increase the volume of the ASB-10.
3. Previous Track
Used to select the previous track of the audio source.
4. Volume Down
Used to reduce the volume of the ASB-10.
5. Mute
Used to mute the sound from the ASB-10. Pressing it again returns the
volume to the previous level.
6. 3D Sound
Used to enable Dolby® Virtual Speaker 2.0, which changes the sound of
the ASB-10 to create a 3 dimensional effect Holding it down for 3 seconds
whilst in standby mode will enable the LED brightness control.
7. Play/ Pause
Used to play/ pause the audio from a Bluetooth source.
8. Next Track
Used to select the next track of the audio source.
9. Source Toggle
Used to toggle through the various analogue and digital inputs.

Getting Started

Deciding on location

The ASB-10 is a very versatile product, it can be placed on a cabinet/ shelf siting it on the supplied rubber feet. It can also be mounted to a wall using screws, which
the ASB-10 will hook onto via keyhole fixings. It can also be mounted below a flat panel TV using the Sanus VMA202 Soundbar Speaker Mount. Refer to www.sanus.com
for further information.

Rubber Feet

The ASB-10 comes with a rubber feet for fitting on the under side of the cabinet. This is used to prevent it from moving when placed on a shelf or cabinet.
4
1
2
3
4
5
ASB-10
6
7
8
9