Advertisement
Manual version: 5P101-20171120
Figure 2 Removing the filler panel from the expansion slot
2.
Unpack the interface card and press the latch to release the ejector lever.
3.
As shown by callout 1 in
rails.
4.
As shown by callout 2 in
ejector lever and secures the card into place.
Figure 3 Installing an interface card in the expansion slot
4 Obtaining documentation
For card installation, see HPE FlexFabric 12900E Switch Series Installation Guide.
For software upgrade, see HPE FlexFabric 12900E Switch Series Software Upgrade Guide.
To access documentation and support services, go to the Hewlett Packard Enterprise Support
Center website:
www.hpe.com/support/hpesc
The information in this document is subject to change without notice.
© Copyright 2017 Hewlett Packard Enterprise Development LP
BOM: 3123A1NA
1
1
2
Figure
3, insert the interface card slowly into the slot along the guide
Figure
3, close the ejector lever. The latch automatically locks the
1
2
v
Part number: 5200-4100
Advertisement
