Figure 7
1. Tensioning cap
2. Spacers
3. Shims
Figure 8
4.
Push the castor spindle through the castor
arm. Install the shims (as they were originally
installed) and the remaining spacers onto the
spindle shaft. Install the tensioning cap to
secure the assembly.
5.
Remove the hairpin and clevis pin securing the
height of cut collar to the height of cut rod on the
rear of the cutting unit
g008866
4. Axle mounting holes
5. Castor wheel
decal100-5622
(Figure
9).
1. Height-of-cut rod
2. Height-of-cut collar
6.
Align the height-of-cut collar to the desired
height-of-cut holes on the height-of-cut rod
(Figure
10).
7.
Secure the adjustment with the clevis pin and
hairpin.
Note:
Position the head of the clevis pin toward
the front of the deck, if possible.
Note:
When using 25 mm (1 inch), 38 mm
(1-1/2 inch), or occasionally 51 mm (2 inch)
height-of-cut, move the skids and roller to the
highest holes.
12
Figure 9
3. Clevis pin and hairpin
cotter
Figure 10
g012231
decal108-1986